Hello Guest
Pages: [1]

1st gen SV front axel spacer dimensions

  • 2 Replies
  • 1179 Views

0 Members and 1 Guest are viewing this topic.

*

SV88

  • *****
  • 555
    +446/-67
1st gen SV front axel spacer dimensions
« on: April 05, 2007, 10:46:42 am »
I cut one out of electrical conduit and used it last year but my brakes are dragging so it's probably not the right width.  What is that dimension (I sold the speedo pick-up.. :biggrin:)
Logged
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions
Fastsv650/SVR6/Steve sv23
09R6rdrace,13KTM250xc enduro,03SV1000N, 99-02 sv650 project
ret. CCS MW/FL/SE 88  Moto A SSP 881
*

racer52

  • **
  • 59
    +11/-7
    • www.pulseracing.org
Re: 1st gen SV front axel spacer dimensions
« Reply #1 on: April 08, 2007, 10:04:05 pm »
I will measure, but i removed the speedo pickup plastic portion and used the existing spacer of the speedo pick up seems to work fine, although you need to get a sealed bearing as the pickup seals that bearing.
Logged
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions
Kerry Kimball
EXP CCS#52
Zimbrick at Fish Hatchery Road
Zimbrick.com

"An amateur works until he gets it right, a professional works until
he can't get it wrong"!
*

SV88

  • *****
  • 555
    +446/-67
Re: 1st gen SV front axel spacer dimensions
« Reply #2 on: April 09, 2007, 12:21:44 pm »
Thanks for the sealed bearing tip.  I'll just keep an eye on the bearing and replace it with a sealed one.  Checked the front wheel drag on my new SV1000 and it's a little less than on the race SV650.  The spacer I cut is probably pretty close anyway..

Steve.
Logged
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions
Fastsv650/SVR6/Steve sv23
09R6rdrace,13KTM250xc enduro,03SV1000N, 99-02 sv650 project
ret. CCS MW/FL/SE 88  Moto A SSP 881
Pages: [1]