636 Front Axle removal

[1fastmofo]

Guys,

Any ideas or suggestions on what to use to remove the front axle on a 636? I've heard of people using the head of a bolt and 2 nuts (insert joke here) instead of buying the hex tools. I went to Home Depot to try and do this, but couldn't find the right size. Anyone successfully do this or have another method that works for them?

Thanks,
Ray

[RidgeRider]

I use one of the sparkplug removal sockets in my craftsman set.  I don't remember which size it is but one of them fits in there perfectly.  Just turn it around, stick a 3/8" extension in it backwards and have at it...

[WebCrush]

you CAN buy the hex tool for $15, ya cheap bastard.

but then again, i didn't either, just purchased a bolt, but two nuts on it, and cut off the end.

I think the size of the bolt head and nuts were 24mm.  I can't remember what size bolt that equated to, but M16 rings a bell.

[1fastmofo]

Yeah yeah,

I know, I'm cheap. You already know I'm race prepping the new 636 for next year. I went ahead and ordered the adapter from LP.

Hey it was good to see you again. Sorry Mary didn't make it this weekend.

Ray

[davegsxrold929r]

hmm a 636 you say....  ;)

[1fastmofo]

Yes Dave,

I'm retiring the F2. Well, not retiring... selling. :)