CCS / ASRA Racing Forum

Author Topic: SV650 Emulator install  (Read 2191 times)

0 Members and 1 Guest are viewing this topic.

dwilson

  • B E
  • 250 - 500 posts
  • *
  • Posts: 415
  • Karma: +1/-0
  • I can see my house from here!
SV650 Emulator install
« on: November 19, 2004, 01:20:12 pm »
I've got a box with 2 shiny new Racetech emulators in it  :)  Also have springs and preload adjuster caps...

I've been told that the best way to install is to drill the holes in the damper rods to 10mm and weld the rebound hole shut.

The Racetech manual says to drill the holes bigger, add 2 more holes and leave the rebound hole alone.

Would anybody like to add a third setup to the list?

I'm going to try 20wt oil too.  I'm going to try the emulators a their stock setting but if anyone can tell me where a good baseline is I'd appreciate it.

The bike is a 2002.
« Last Edit: November 19, 2004, 01:20:46 pm by dwilson »
Don Wilson
North East Philly
Y2K SV650
CCS # 321

dwilson

  • B E
  • 250 - 500 posts
  • *
  • Posts: 415
  • Karma: +1/-0
  • I can see my house from here!
Re: SV650 Emulator install
« Reply #1 on: November 19, 2004, 01:26:01 pm »
Nevermind...
It turns out I asked this same question with my last SV650...

http://www.racemotorcycles.com/cgi-bin/board/YaBB.pl?board=tips;action=display;num=1079545918;start=
Don Wilson
North East Philly
Y2K SV650
CCS # 321