Map

 CCS / ASRA Racing Forum

Author Topic: 07 / 08 ZX6R keyless ignition?  (Read 3783 times)

0 Members and 1 Guest are viewing this topic.

avdigigeek

  • Backmarker
  • **
  • Posts: 79
  • Karma: +10/-12
  • slow and low...
07 / 08 ZX6R keyless ignition?
« on: January 03, 2011, 11:04:14 pm »
Hey All,
Looking to go keyless on my 07 zx6r.
I'm trying to get rid of everything I can on the bike.
Thanks in advance for any help.
Smiley

cMac

  • B E
  • Backmarker
  • *
  • Posts: 15
  • Karma: +2/-0
Re: 07 / 08 ZX6R keyless ignition?
« Reply #1 on: March 13, 2011, 06:25:43 pm »
I wired min to the start stop switch but your going to need to wire a 1.5 ohm resistor from to ECU. The ECU looks for that resistance to prime the pump and send the signal to fire the starter.
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions

LilJayRR

  • 250 - 500 posts
  • ****
  • Posts: 311
  • Karma: +26/-15
Re: 07 / 08 ZX6R keyless ignition?
« Reply #2 on: March 14, 2011, 11:56:00 pm »
You should have 7 wires in the ignition switch. One is the 12v source that runs everything, wire it into the bar switch, and the others to the output.  Between the grey and brown wires you need a resistor. I've always used 100 ohm. Then i wire the two wires that used to run to the bar switch together.
That should do it.   
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions
Jason Gibbens
Expert #62 Mid-Atlantic
2007 GTU Team Challenge Champions!
2009 ZX6R RnR Cycles, Repsol, Dunlop, Woodcraft