Map

 CCS / ASRA Racing Forum

Author Topic: sv superbike jetting  (Read 1940 times)

0 Members and 1 Guest are viewing this topic.

opie158

  • Guest
sv superbike jetting
« on: April 04, 2006, 09:33:00 am »
What jetting should I start with for my superbike powered sv? This is what it has, 1mm overbore, APE cams, ballanced crank, Khinin 41mm flat slides, light flywheel, total loss ignition. Will be at Summit point mostly. Also what gearing can some recomend? Thanks for any and all help.
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions

damico

  • Guest
Re: sv superbike jetting
« Reply #1 on: April 04, 2006, 11:14:51 am »
175 MAINS WILL BE A GOOD PLACE TO START FOR JETTING. BUT ALSO HAVE A PAIR OF 172 JETS ON HAND. THAT SHOULD GET YOU REAL CLOSE
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions

opie158

  • Guest
Re: sv superbike jetting
« Reply #2 on: April 04, 2006, 12:36:46 pm »
Thanks!!!
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions

catman

  • Guest
Re: sv superbike jetting
« Reply #3 on: January 31, 2007, 01:42:25 am »
GEARING? ANYONE for summit point sv superbike?
« Last Edit: January 31, 2007, 07:48:25 am by CATMAN »
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions


badmonkey

  • 100 - 250 posts
  • ***
  • Posts: 227
  • Karma: +7/-7
  • I'm not fast, your just slow!
Re: sv superbike jetting
« Reply #4 on: February 17, 2007, 04:55:30 pm »
try 160 mains unless running oxygenated fuel . then 175 otherwise way too rich...
16-46 gearing on superbike
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions
Do you want to touch my Monkey?

citygarage

  • Guest
Re: sv superbike jetting
« Reply #5 on: February 24, 2007, 02:44:59 pm »
try 160 mains unless running oxygenated fuel . then 175 otherwise way too rich...
16-46 gearing on superbike


that jetting sounds way wrong. my stock motor with flatslides runs lean but in the horsepower with 160's. and it sounds like your saying run 160 with normal fuel and 175 with oxygenated fuel. are you saying you make a seven step increase in your jets when you switch to oxygenated fuel? that sounds super wrong, the furthest we have ever gone was two steps, and that took us from slightly lean with normal fuel to almost perfect with race fuel.
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions

Super Dave

  • I hate salad...
  • More than 1,000 posts
  • ******
  • Posts: 11412
  • Karma: +1260/-454
  • I'm the ghost with the most...
Re: sv superbike jetting
« Reply #6 on: February 24, 2007, 03:15:44 pm »
Would be contingent upon the specific gravity of the fuels you are comparing and the amount of oxygenate.  Both can make your jetting change one way or another in jet sizes.
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions
Super Dave

badmonkey

  • 100 - 250 posts
  • ***
  • Posts: 227
  • Karma: +7/-7
  • I'm not fast, your just slow!
Re: sv superbike jetting
« Reply #7 on: February 25, 2007, 06:14:27 pm »
What fuel you running? Built motors you tend to run higher octane which means you usually run a leaner jet. Bigger jets don't mean more hp. I went from a stock motor with slides , 72 hp, to a built motor cams pistons whole nine yards 89hp and didn't have to rejet carbs except for diff temps. Try a dyno with a sniffer. You results may vary...LOL
« Last Edit: February 25, 2007, 06:17:28 pm by badmonkey »
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions
Do you want to touch my Monkey?


Super Dave

  • I hate salad...
  • More than 1,000 posts
  • ******
  • Posts: 11412
  • Karma: +1260/-454
  • I'm the ghost with the most...
Re: sv superbike jetting
« Reply #8 on: February 25, 2007, 06:33:16 pm »
I disagree that octane affects jetting.  But you might have other variables.
Like
0
Dislike
0
Agree
0
Disagree
0
No reactions
No reactions
No reactions
No reactions
Super Dave