Hey All,
Looking to go keyless on my 07 zx6r.
I'm trying to get rid of everything I can on the bike.
Thanks in advance for any help.
Smiley

I wired min to the start stop switch but your going to need to wire a 1.5 ohm resistor from to ECU. The ECU looks for that resistance to prime the pump and send the signal to fire the starter.

You should have 7 wires in the ignition switch. One is the 12v source that runs everything, wire it into the bar switch, and the others to the output.  Between the grey and brown wires you need a resistor. I've always used 100 ohm. Then i wire the two wires that used to run to the bar switch together.
That should do it.