I had to pull motor ,cuz one of gears was slipping out(rounded off dog) well, now that I'm in there what else should I change for investigate. other than
rings & crank bearings....easy stuff
Do I have to change all gears/wheels or just the one that got rounded off.
Do I have to changes pistons and rod bearings. Or just rod bearings........need help please.
Change the two affected gears(male and female gears if you will in relation to the dogs).
Check shift drum and shiftforks the forks for the damaged gear I would replace just for my own piece of mind
I would also do the cam chain.
But also what bike is this? how many miles?
I would check the clutch basket and cltuch plates, if you replace them I always out a new throw out bearing in when I do those.
sorry , this is a 99 r6,..........i think it has about 10-12k on it........
I'm going to do the
shift forks
crank/rod bearings
gears effected
rings
head gasket
any other ideas
10-12k race miles?
if so I would check bore and pistons as well as have the rods magna fluxed(checked for factures)
If street miles then I would not think it was needed at this time.
valve job
it's a race bike, and pistons were changed last year
kevin gordons old bike,..........
i've only raced it 1/2 a season so i should be fine right?
i just had to go in cause gear was slipping in/out.
just doing preventative while I'm in there