rebuilding motor??

[Malik]

I had to pull motor ,cuz one of gears was slipping out(rounded off dog) well, now that I'm in there what else should I change for investigate. other than

rings & crank bearings....easy stuff

Do I have to change all gears/wheels or just the one that got rounded off.

Do I have to changes pistons and rod bearings. Or just rod bearings........need help please.

[Eric Kelcher]

Change the two affected gears(male and female gears if you will in relation to the dogs).

Check shift drum and shiftforks the forks for the damaged gear I would replace just for my own piece of mind

I would also do the cam chain.

But also what bike is this? how many miles?

I would check the clutch basket and cltuch plates, if you replace them I always out a new throw out bearing in when I do those.

[Malik]

sorry , this is a 99 r6,..........i think it has about 10-12k on it........

I'm going to do the

shift forks
crank/rod bearings
gears effected
rings
head gasket

any other ideas

[Eric Kelcher]

10-12k race miles?

if so I would check bore and pistons as well as have the rods magna fluxed(checked for factures)

If street miles then I would not think it was needed at this time.

valve job

[Malik]

it's a race bike, and pistons were changed last year

kevin gordons old bike,..........

i've only raced it 1/2 a season so i should be fine right?

i just had to go in cause gear was slipping in/out.

just doing preventative while I'm in there